MichiGeek Designs- 20 sided die snaptab

OK this is going to come as a shock but when I was young I was very into gaming. No not Nintendo 64 Mario cart or any of those games, I was a serious LAN addicted girl who could put the boys to shame with my battle skills. So when a new digitizer popped up, the designs were definitely on my 'must buy now' radar. They are not only unique but they are very geeky and here is a review of a  snap tab that I just love! 


20 sided die Snaptab

Created and developed by: MichiGeek designs (BUY HERE)

Cost:  $4.00 (US)

Embroidered on: Husqvarna Topaz 20

Size Available:  4×4 and up.

Instructions: No

Skill level: Beginner to advanced.

Time taken: 20 min after fabric cut out

Stabilizer used: I used medium weight tear away. 

This is a simple snap tab design. For those who haven't ever done a snap-tab before the steps are simple. Stitch out the placement,   Place the top fabric on, stitch out the details and then put the backing on before the final stitches. You then just need to cut it out and apply the KAM snaps.  I love snap tabs because they are quick and easy as well as appealing to  men, woman and even children (Bag tags!!!). MichiGeek die stitched out beautifully. I was worried about the small stitches but i had no problems at all. A tip is I usually find trimming between the numbers tricky but by using a sharp sewing Awl and VERY carefully slipping it under the thread, you can lift it up and trim it easily and quite close to the ends.

MichiGeek certainly has unique but awesome designs, check them out today! (Oh and tell them i sent you :) )